|
LaCrO3/CuFe2O4 composite coated Crofer 22 APU stainless steel interconnect of solid oxide fuel cells
|
# |
1396 - 04 |
|
Physical mechanical and dry sliding wear propertiesof hybrid and non-hybrid Al-V nanocomposites produced by powder metallurgy
|
# |
1396 - 04 |
|
Dependence of corrosion properties of AISI 304L stainless steel on the austenite grain size
|
# |
1396 - 04 |
|
Thermal stability evaluation of nanostructured Al6061 alloy produced by cryorolling
|
# |
1396 - 02 |
|
Investigation of amorphous phase formation in Fe-Co-Si-B-P - Thermodynamic analysis and comparison between mechanical alloying and rapid solidification experiments
|
# |
1396 - 01 |
|
The effect of slip casting parameters on the green density of MgAl2O4 spinel
|
# |
1396 - 01 |
|
Evaluation of microstructure and mechanical properties of bulk nanostructured Ti5Si3 and Ti5Si3-Al2O3 nanocomposite
|
# |
1395 - 10 |
|
Mechanical and tribological behavior of severely plastic deformed Al6061 at cryogenic temperatures
|
# |
1395 - 10 |
|
Amorphization and Nanocrystallization of Ni-Nb-Si Alloys
|
# |
1395 - 10 |
|
Austenite formation and mechanical properties of a cold rolled ferrite-martensite structure during intercritical annealing
|
# |
1395 - 10 |
|
Nanocrystallization of Al powder by cryomilling process
|
# |
1395 - 10 |
|
Fabrication of Bulk (Fe,Cr)3Al\/Al2O3 Intermetallic Matrix Nanocomposite Through Mechanical Alloying and Sintering
|
10.1007/s40195-016-0465-3 |
1395 - 07 |
|
The tribological properties of Cu-Ni3Al-MoS2 composite coating deposited by magnetron sputtering
|
# |
1395 - 07 |
|
Fabrication of bulk (Fe Cr)3Al/Al2O3 intermetallic matrix nanocomposite through mechanical alloying and sintering
|
# |
1395 - 07 |
|
Formation mechanism crystallite growth and electrical conductivityof nano-crystalline CuxFe3-xO4(0.75 x 1.25) spinels prepared byglycine-nitrate process
|
# |
1395 - 04 |
|
Effect of friction stir processing on microstructure and mechanical properties of AZ91C magnesium cast alloy weld zone
|
# |
1395 - 04 |
|
Microstructural evolution and recrystallization kinetics of a cold rolled ferrite-martensite structure during intercritical annealing
|
# |
1395 - 04 |
|
Oxidation and electrical behavior of CuFe2O4 spinel coated Crofer 22 APU stainless steel for SOFC interconnect application
|
# |
1395 - 04 |
|
The influence of volume fraction of martensite and ferrite grain size on ultimate tensile strength and maximum uniform true strain of dual phase steel
|
# |
1395 - 04 |
|
Effects of Friction Stir Process Parameters on Microstructure and Mechanical Properties of Aluminium Powder Metallurgy Parts
|
# |
1395 - 01 |