A Comparative Study on Wear Properties of Nanostructured Al and Al/Al2O3 Nanocomposite Prepared by Microwave-Assisted Hot Press Sintering and Conventional Hot Pressing
|
# |
|
Journal |
Preparation of nano-particles from waste tire rubber and evaluation of their effectiveness as zinc source for cucumber in nutrient solution culture
|
# |
|
Journal |
A novel route for development of Al-Cr-O surface nano-composite by friction stir processing
|
# |
|
Journal |
Investigation of the effects of grain size and nano-sized reinforcements on tribological properties of Ti6Al4V alloy
|
# |
|
Journal |
Wear characteristics of Al-Cr-O surface nano-composite layer fabricated on Al6061 plate by friction stir processing
|
# |
|
Journal |
In-situ fabrication of Al3V/Al2O3 nanocomposite through mechanochemical synthesis and evaluation of its mechanism
|
# |
|
Journal |
Thermodynamic analysis of solid solution formation in nanocrystalline Fe-Ti-Al ternary system during mechanical alloying
|
# |
|
Journal |
Properties of bulk Fe-Ni/CNT nanocomposites prepared by mechanical milling and sintering
|
# |
|
Journal |
Kinetic study of non-isothermal crystallization in Al80Fe10Ti5Ni5 metallic glass
|
# |
|
Journal |
Development of Al356-Al2O3 nanocomposite coatings by high velocity oxy-fuel technique
|
# |
|
Journal |
Thermodynamic analysis of Ti Al C intermetallics formation by mechanical alloying
|
# |
|
Journal |
Microstructural and wear characteristics of HVOF-sprayed nanocrystalline NiAl coating
|
# |
|
Journal |
Synthesis of (Fe Cr)3Al-Al2O3 nanocomposite through mechanochemical combustion reaction induced by ball milling of Cr Al and Fe2O3 powders
|
# |
|
Journal |
Study on the wear behavior of ultrafine grained 304L stainless steel
|
# |
|
Journal |
Synthesis of Cu-Zr-Al/Al2O3 amorphous nanocomposite by mechanical alloying
|
# |
|
Journal |
Microstructure and Mechanical Property Change During FSW and GTAW of Al6061 Alloy
|
# |
|
Journal |
In-Situ Synthesis of Alumina Reinforced (Fe,Cr)3Al Intermetallic Matrix Nanocomposite
|
10.1080/10426914.2012.663141 |
|
Journal |
Thermodynamic analysis and characterisation of nanostructured Cu(Mo) compounds prepared by mechanical alloying and subsequent sintering
|
# |
|
Journal |
Thermodynamic aspects of nanostructured Ti5Si3 formation during mechanical alloying and its characterization
|
# |
|
Journal |
Rapid carbothermic synthesis of silicon carbide nano powders by using microwave heating
|
# |
|
Journal |