|
Experimental Study of NiTi Thin-Walled Tubes Under Uniaxial Tension Torsion Proportional and Non-Proportional Loadings
|
# |
1394 - 04 |
|
Thermomechanical Modeling of Stress Relaxation in Shape Memory Alloy Wires
|
# |
1394 - 01 |
|
A modified constitutive model with an enhanced phase diagram for ferromagnetic shape memory alloys
|
# |
1394 - 01 |
|
A comprehensive energy approach to predict fatigue life in CuAlBe shape memory alloy
|
# |
1393 - 11 |
|
Finite element simulation of shape memory alloy wires using a user material subroutine Parametric study on heating rate conductivity and heat convection
|
# |
1393 - 11 |
|
Microplane modeling of shape memory alloy tubes under tension torsion and proportional tension-torsion loading
|
# |
1393 - 10 |
|
A Computationally Efficient Modeling Approach for Predicting Mechanical Behavior of Cellular Lattice Structures
|
# |
1393 - 10 |
|
Behaviors of Ferromagnetic Shape Memory Alloy Ni Mn Ga Under Incomplete Magneto-Mechanical Loading Unloading Cycles
|
# |
1393 - 08 |
|
A geometrical approach to determine reorientation start and continuation conditions in ferromagnetic shape memory alloys considering the effects of loading history
|
# |
1393 - 07 |
|
A cycle-dependent phase diagram to investigate the thermomechanical behavior of shape memory alloy wires under cyclic loadings
|
# |
1393 - 07 |
|
Anisotropic behavior of superelastic NiTi shape memory alloys an experimental investigation and constitutive modeling
|
# |
1393 - 07 |
|
A non-local implicit gradient-enhanced model for unstable behaviors of pseudoelastic shape memory alloys in tensile loading
|
# |
1393 - 07 |
|
Numerical investigation on mechanical properties of cellular lattice structures fabricated by fused deposition modeling
|
# |
1393 - 07 |
|
Asymmetrical rolling analysis of bonded two-layer sheets and evaluation of outgoing curvature
|
# |
1393 - 04 |
|
Constitutive modeling of tension-torsion coupling and tension-compression asymmetry in NiTi shape memory alloys
|
# |
1393 - 04 |
|
A thermodynamically-consistent microplane model for shape memory alloys
|
# |
1393 - 04 |
|
An Investigation into the Simple Tensile Test of SMA Wires Considering Stress Concentration of Grippers
|
# |
1392 - 12 |
|
New multi-pass hot channel section rolling design by the finite element method
|
# |
1392 - 09 |
|
An investigative study on the performance of twist roll machine in a continuous cold strip rolling mill
|
# |
1392 - 05 |
|
Experimental Study on the magnetomechanical characteristics of Ni-Mn-Ga Ferromagnetic Shape Memory Alloy Single Crystals
|
# |
1391 - 12 |