Dynamic Anaylsis and Critical Speed of Pressurized Rotating Composite Laminated Conical Shells Using Generalized Differential Quadrature Method
|
|
Rotor crack detection using pattern search and genetic algorithm
|
|
Critical velocities for beams subjected to moving constant loads
|
|
Interior Acoustic Behavior Optimization of a Roadway Vehicle by Means of Passive Layer Treatment Using Finite Element Method
|
|
Prediction of Pig Motion through Natural Gas Pipelines
|
|
Numerical Simulation of a 200 MW Industrial Boiler
|
|
Worst Specification for Forced Vibration Response of Mistuned Bladed Disk
|
|
Comparison between DET and FEM in vibration analysis of beams subjected to moving loads
|
|
Operational Modal Analysis (OMA) and its applications to experimental vibration analysis of civil engineering structures
|
|
Operational modal analysis of a post-tensioned concrete skew bridge before and after replacement of its elastomeric bearings
|
|
Further Investigation on Chatter Analysis in cold rolling mills for Finding the Optimum Range of Design parameters
|
|
Further Investigation on Chatter Analysis in Cold Rolling Mills for Finding Optimum Range of Design Parameters
|
|
Thermo-mechanical Analysis and Microstructural Evolution in Hot Strip Rolling.
|
|
Finite Element Modelling of Strain-Stiffening in Biaxial Hot Drawing Process of Poly(Ethylene Tetreohthalate)
|
|
Forced Vibration of Mindlin-Reissner Thick Plate with Layers of Piezoelectric Sensors and Actuators
|
|
Failure characterisation of Ti6Al4V gas turbine compressor blades
|
|
Fabrication of A Biped Robot and Optimization of Its Kinematics Tragectories Based on Relative Coordinates and Bezier Splines
|
|
Finite Element Analysis of Tensile Mechanical Properties in Nanocrystaline Materials
|
|
ESTIMATION OF ELASTOMERIC BRIDGE BEARING SHEAR MODULUS USING OPERATIONAL MODAL ANALYSIS
|
|
Modeling considerations and material properties evaluation in analysis of polymer carbon nanotubes by using of square representative volume elements
|
|