| Permanent Deformation of Thermoplastic Polyurethane in the Solid-State Rolling Process |
10.1155/adv/8811192 |
|
Journal |
| Multi-objective optimization of the design parameters in longitudinal corrugated tubes to improve crashworthiness performance |
# |
|
Journal |
| Isogeometric micromechanical damage analysis of fiber-reinforced composites by presenting a single-patch framework |
# |
|
Journal |
| Cooling pattern on the run-out table of a hot rolling mill for an HSLA steel: a finite element analysis |
10.1007/s00170-024-13513-y |
|
Journal |
| On the crashworthiness performance of thin-walled circular tubes: Effect of diameter and thickness |
10.1080/15376494.2023.2206839 |
|
Journal |
| Theoretical and experimental investigations for noise reduction of clearance joints in vertical vibrations |
# |
|
Journal |
| Micromechanical evaluation of failure models for unidirectional fiber-reinforced composites |
10.1177/0021998319867470 |
|
Journal |
| Damage and residual bending strength in glass-polyester molded grating composite panels after low-velocity impact |
10.1016/j.compstruct.2019.111290 |
|
Journal |
| Effect of Interstand Tensions on Lubrication Regime in Cold Strip Rolling with O/W Emulsion |
10.1080/10402004.2018.1536238 |
|
Journal |
| Increasing the chatter instability speed limit in cold strip rolling using wavy layered composite plates as a damper |
10.1016/j.tws.2018.12.004 |
|
Journal |
| Experimental analysis of vibration and sound in order to investigate chatter phenomenon in cold strip rolling |
10.1007/s00170-018-2639-9 |
|
Journal |
| Formulation of a consistent pressure-dependent damage model with fracture energy as input |
10.1016/j.compstruct.2018.06.005 |
|
Journal |
| Development and evaluation of friction models for chatter simulation in cold strip rolling |
10.1007/s00170-018-1658-x |
|
Journal |
| A damage mechanics based failure criterion for fiber reinforced polymers |
# |
|
Journal |
| Predicting the buckling behavior of pultruded beams under axial static compression |
# |
|
Journal |
| Examination and modeling of void growth kinetics in modern high strength dual phase steels during uniaxial tensile deformation |
# |
|
Journal |
| Void coalescence and fracture behavior of notched and un-notched tensile tested specimens in fine grain dual phase steel |
# |
|
Journal |
| Influence of bainite morphology on ductile fracture behavior in a 0.4C-CrMoNi steel |
# |
|
Journal |
| Theoretical and Experimental Analysis of Chatter in Tandem Cold Rolling Mills Based on Wave Propagation Theory |
# |
|
Journal |
| Improvement of ECAP process by imposing ultrasonic vibrations |
# |
|
Journal |