|
Permanent Deformation of Thermoplastic Polyurethane in the Solid-State Rolling Process
|
10.1155/adv/8811192 |
1403 - 10 |
|
Multi-objective optimization of the design parameters in longitudinal corrugated tubes to improve crashworthiness performance
|
# |
1403 - 09 |
|
Isogeometric micromechanical damage analysis of fiber-reinforced composites by presenting a single-patch framework
|
# |
1403 - 04 |
|
Cooling pattern on the run-out table of a hot rolling mill for an HSLA steel: a finite element analysis
|
10.1007/s00170-024-13513-y |
1403 - 01 |
|
On the crashworthiness performance of thin-walled circular tubes: Effect of diameter and thickness
|
10.1080/15376494.2023.2206839 |
1402 - 01 |
|
Theoretical and experimental investigations for noise reduction of clearance joints in vertical vibrations
|
# |
1401 - 04 |
|
Micromechanical evaluation of failure models for unidirectional fiber-reinforced composites
|
10.1177/0021998319867470 |
1398 - 12 |
|
Damage and residual bending strength in glass-polyester molded grating composite panels after low-velocity impact
|
10.1016/j.compstruct.2019.111290 |
1398 - 08 |
|
Effect of Interstand Tensions on Lubrication Regime in Cold Strip Rolling with O/W Emulsion
|
10.1080/10402004.2018.1536238 |
1398 - 02 |
|
Increasing the chatter instability speed limit in cold strip rolling using wavy layered composite plates as a damper
|
10.1016/j.tws.2018.12.004 |
1398 - 01 |
|
Experimental analysis of vibration and sound in order to investigate chatter phenomenon in cold strip rolling
|
10.1007/s00170-018-2639-9 |
1397 - 10 |
|
Formulation of a consistent pressure-dependent damage model with fracture energy as input
|
10.1016/j.compstruct.2018.06.005 |
1397 - 07 |
|
Development and evaluation of friction models for chatter simulation in cold strip rolling
|
10.1007/s00170-018-1658-x |
1396 - 12 |
|
A damage mechanics based failure criterion for fiber reinforced polymers
|
# |
1395 - 10 |
|
Predicting the buckling behavior of pultruded beams under axial static compression
|
# |
1395 - 02 |
|
Examination and modeling of void growth kinetics in modern high strength dual phase steels during uniaxial tensile deformation
|
# |
1394 - 10 |
|
Void coalescence and fracture behavior of notched and un-notched tensile tested specimens in fine grain dual phase steel
|
# |
1394 - 04 |
|
Influence of bainite morphology on ductile fracture behavior in a 0.4C-CrMoNi steel
|
# |
1394 - 02 |
|
Theoretical and Experimental Analysis of Chatter in Tandem Cold Rolling Mills Based on Wave Propagation Theory
|
# |
1394 - 01 |
|
Improvement of ECAP process by imposing ultrasonic vibrations
|
# |
1393 - 11 |